Spend A Day With A Motor Grader Operator

Motor grader operators normally work in areas such as new sub-divisions, parking lots, airport runways, highways, country roads, and the final stages of general road construction. Like all heavy equipment operators, they require specialist skills for their equipment. Like crane operators, motor grader operators work to fine measurements often using new technology such as GPS and lasers.

The day starts early for a motor grader operator and they are generally required to start at the site they are to work on. Like all heavy equipment operators there is a standard routine to the morning. A briefing with the site managers to discuss the current state of construction. An inspection of blue prints and the order of work for the day.

Once the operator knows what he/she is doing, it is time to inspect their equipment to ensure everything is ready to go. One of the problems with leaving equipment on a construction site is damage caused by third parties. This could include willful damage by vandals, or damage from animals. One area that motor grader operators need to examine closely are their tires. Other heavy equipment often use caterpillar treads, motor graders use large tires and these need to be checked for cuts, tears and for objects that may have lodged in the tires. If all is well – it is off to start the job.

It may look boring, just driving up and down a new stretch of highway. It’s not. Each pass is made to a specific degree of angle and depth. Even the speed of the vehicle can determine what sort of finish you get. There are times when the grader will work on stretch of new road, move to another stretch that afternoon and be back to the start the following morning after new material such as gravel or road base has been added. Whilst they are concentrating on the task at hand, they must also be vigilant of everything that is happening around them so they can avoid any accidents. Safety is primary in all heavy equipment jobs.

Motor grader operators often work long hours. Their day is not done until the pass they are working on has been completed. Even then, they need to secure their vehicle and perform an end of day inspection of the equipment.

Want to work as a motor grader operator? Training is done in as little as three weeks. Just be sure the motor grader training you receive is from an accredited training organization and that the training itself has been accredited.